[Nov 03, 2023] Fortinet NSE7_EFW-7.0 Exam Dumps Are Essential To Get Good Marks
Latest Fortinet NSE7_EFW-7.0 Dumps with Test Engine and PDF (New Questions)
Fortinet NSE7_EFW-7.0 certification exam is a challenging exam that requires a significant amount of preparation and study. Candidates who are looking to take NSE7_EFW-7.0 exam should have a strong understanding of enterprise firewall technologies and should be familiar with the latest industry trends and best practices. Additionally, candidates should have practical experience working with enterprise firewalls in a professional setting.
NEW QUESTION # 43
Refer to the exhibit, which contains a TCL script configuration on FortiManager.
An administrator has configured the TCL script on FortiManager, but the TCL script failed to apply any changes to the managed device after being run.
Why did the TCL script fail to make any changes to the managed device?
- A. Changes to an interface configuration can be made only by a CLI script.
- B. The TCL script must start with tinclude <>.
- C. The TCL command run_cmd has not been created.
- D. Incomplete commands are ignored in TCL scripts.
Answer: C
Explanation:
https://docs.fortinet.com/document/fortimanager/7.2.2/administration-guide/914165/tcl-scripts
NEW QUESTION # 44
An administrator has configured two FortiGate devices for an HA cluster. While testing the HA failover, the administrator noticed that some of the switches in the network continue to send traffic to the former primary unit. The administrator decides to enable the setting link-failed-signal to fix the problem. Which statement is correct regarding this command?
- A. Forces the former primary device to shut down all its non-heartbeat interfaces for one second while the failover occurs.
- B. Sends a link failed signal to all connected devices.
- C. Disables all the non-heartbeat interfaces in all the HA members for two seconds after a failover.
- D. Sends an ARP packet to all connected devices, indicating that the HA virtual MAC address is reachable through a new master after a failover.
Answer: A
NEW QUESTION # 45
Refer to the exhibit, which contains the debug output of diagnose dvm device list.
Which two statements about the output shown in the exhibit are correct? (Choose two.)
- A. The FortiGate configuration is in sync with latest running revision history.
- B. ADOMs are disabled on the FortiManager
- C. There are pending device-level changes yet to be installed on Local-FortiGate.
- D. The policy package has been modified for Local-FortiGate.
Answer: A,C
NEW QUESTION # 46
Examine the partial output from two web filter debug commands; then answer the question below:
Based on the above outputs, which is the FortiGuard web filter category for the web site www.fgt99.com?
- A. Finance and banking
- B. Information technology.
- C. Business.
- D. General organization.
Answer: C
NEW QUESTION # 47
An administrator has configured two FortiGate devices for an HA cluster. While testing the HA failover, the administrator noticed that some of the switches in the network continue to send traffic to the former primary unit. The administrator decides to enable the setting link-failed-signal to fix the problem .
Which statement is correct regarding this command?
- A. Forces the former primary device to shut down all its non-heartbeat interfaces for one second while the failover occurs.
- B. Sends a link failed signal to all connected devices.
- C. Disables all the non-heartbeat interfaces in all the HA members for two seconds after a failover.
- D. Sends an ARP packet to all connected devices, indicating that the HA virtual MAC address is reachable through a new master after a failover.
Answer: A
NEW QUESTION # 48
Examine the output of the 'get router info ospf neighbor' command shown in the exhibit; then answer the question below.
Which statements are true regarding the output in the exhibit? (Choose two.)
- A. The local FortiGate is the backup designated router for the wan1 network.
- B. The OSPF routers with the IDs 0.0.0.69 and 0.0.0.117 are both designated routers for the wan1 network.
- C. The OSPF router with the ID 0.0.0.2 is the designated router for the ToRemote network.
- D. The interface ToRemote is OSPF network type point-to-point.
Answer: A,D
NEW QUESTION # 49
An administrator added the following Ipsec VPN to a FortiGate configuration:
configvpn ipsec phasel -interface
edit "RemoteSite"
set type dynamic
set interface "portl"
set mode main
set psksecret ENC LCVkCiK2E2PhVUzZe
next
end
config vpn ipsec phase2-interface
edit "RemoteSite"
set phasel name "RemoteSite"
set proposal 3des-sha256
next
end
However, the phase 1 negotiation is failing. The administrator executed the IKF real time debug while attempting the Ipsec connection. The output is shown in the exhibit.
What is causing the IPsec problem in the phase 1 ?
- A. The pre-shared key is wrong
- B. The incoming IPsec connection is matching the wrong VPN configuration
- C. NAT-T settings do not match
- D. The phrase-1 mode must be changed to aggressive
Answer: A
NEW QUESTION # 50
View the exhibit, which contains a partial output of an IKE real-time debug, and then answer the question below.
Based on the debug output, which phase-1 setting is enabled in the configuration of this VPN?
- A. auto-discovery-forwarder
- B. auto-discovery-shortcut
- C. auto-discovery-sender
- D. auto-discovery-receiver
Answer: A
NEW QUESTION # 51
View the exhibit, which contains the partial output of a diagnose command, and then answer the question below.
Based on the output, which of the following statements is correct?
- A. Quick mode selectors are disabled.
- B. DPD is disabled.
- C. Remote gateway IP is 10.200.5.1.
- D. Anti-reply is enabled.
Answer: D
NEW QUESTION # 52
View the exhibit, which contains the output of a BGP debug command, and then answer the question below.
Which of the following statements about the exhibit are true? (Choose two.)
- A. The local BGP peer has not established a TCP session to the BGP peer 10.200.3.1.
- B. For the peer 10.125.0.60, the BGP state of is Established.
- C. The local BGP peer has received a total of three BGP prefixes.
- D. Since the BGP counters were last reset, the BGP peer 10.200.3.1 has never been down.
Answer: A,B
NEW QUESTION # 53
View the exhibit, which contains the output of a debug command, and then answer the question below.
Which of the following statements about the exhibit are true? (Choose two.)
- A. The local FortiGate has been elected as the OSPF backup designated router.
- B. Port4 is connected to the OSPF backbone area.
- C. The local FortiGate's OSPF router ID is 0.0.0.4
- D. In the network on port4, two OSPF routers are down.
Answer: B,C
NEW QUESTION # 54
When does a RADIUS server send an Access-Challenge packet?
- A. The user account is not found in the server.
- B. The server does not have the user credentials yet.
- C. The user credentials are wrong.
- D. The server requires more information from the user, such as the token code for two-factor authentication.
Answer: D
NEW QUESTION # 55
Refer to the exhibit, which shows the output of diagnose sys session stat.
Which statement about the output shown in the exhibit is correct?
- A. All the sessions in the session table are TCP sessions.
- B. There are two sessions that have not been removed in case of any out-of-order packets that arrive.
- C. There are 166 TCP sessions waiting to complete the three-way handshake.
- D. 162 sessions have been deleted because of memory page exhaustion.
Answer: B
NEW QUESTION # 56
Examine the output from the BGP real time debug shown in the exhibit, then the answer the question below:
Which statements are true regarding the output in the exhibit? (Choose two.)
- A. The state of the remote BGP peer will go to Connect after it confirms the received prefixes.
- B. The state of the remote BGP peer is OpenConfirm.
- C. Local BGP peer received a prefix fora default route.
- D. BGP peers have successfully interchanged Open and Keepalive messages.
Answer: C,D
NEW QUESTION # 57
Examine the output of the 'get router info bgp summary' command shown in the exhibit; then answer the question below.
Which statement can explain why the state of the remote BGP peer 10.200.3.1 is Connect?
- A. The local peer is receiving the BGP keepalives from the remote peer but it has not received any BGP prefix yet.
- B. The TCP session for the BGP connection to 10.200.3.1 is down.
- C. The local peer has received the BGP prefixed from the remote peer.
- D. The local peer is receiving the BGP keepalives from the remote peer but it has not received the OpenConfirm yet.
Answer: B
Explanation:
http://www.ciscopress.com/articles/article.asp?p=2756480&seqNum=4
NEW QUESTION # 58
View the exhibit, which contains a partial web filter profile configuration, and then answer the question below.
Which action will FortiGate take if a user attempts to access www.dropbox.com, which is categorized as File Sharing and Storage?
- A. FortiGate will exempt the connection based on the Web Content Filter configuration.
- B. FortiGate will block the connection based on the URL Filter configuration.
- C. FortiGate will allow the connection based on the FortiGuard category based filter configuration.
- D. FortiGate will block the connection as an invalid URL.
Answer: B
NEW QUESTION # 59
An administrator cannot connect to the GIU of a FortiGate unit with the IP address 10.0.1.254. The administrator runs the debug flow while attempting the connection using HTTP.
The output of the debug flow is shown in the exhibit:
Based on the error displayed by the debug flow, which are valid reasons for this problem? (Choose two.)
- A. HTTP administrative access is configured with a port number different than 80.
- B. Redirection of HTTP to HTTPS administrative access is disabled.
- C. HTTP administrative access is disabled in the FortiGate interface with the IP address 10.0.1.254.
- D. The packet is denied because of reverse path forwarding check.
Answer: A,C
NEW QUESTION # 60
View the exhibit, which contains the partial output of a diagnose command, and then answer the question below.
Based on the output, which of the following statements is correct?
- A. Quick mode selectors are disabled.
- B. DPD is disabled.
- C. Remote gateway IP is 10.200.5.1.
- D. Anti-reply is enabled.
Answer: D
NEW QUESTION # 61
View these partial outputs from two routing debug commands:
Which outbound interface will FortiGate use to route web traffic from internal users to the Internet?
- A. Both port1 and port2
- B. port1
- C. port3
- D. port2
Answer: B
NEW QUESTION # 62
Which two statements about the Security Fabric are true? (Choose two.)
- A. Only FortiGate devices with fabric-object-unification set to default will receive and synchronize global CMDB objects sent by the root FortiGate.
- B. Only the root FortiGate sends logs to FortiAnalyzer.
- C. Only the root FortiGate collects network topology information and forwards it to FortiAnalyzer.
- D. FortiGate uses FortiTelemetry protocol to communicate with FortiAnalyzer.
Answer: A,C
Explanation:
FortiGate's to Root uses FortiTelemetry (TCP-8013) FortiTelemetry is also used for FortiClient communication Root Fortigate to FortiAnalyzer uses API (TCP-443)
NEW QUESTION # 63
Which statement about NGFW policy-based application filtering is true?
- A. FortiGate will drop all packets until the application can be identified.
- B. After the application has been identified, the kernel uses only the Layer 4 header to match the traffic.
- C. After IPS identifies the application, it adds an entry to a dynamic ISDB table.
- D. The IPS security profile is the only security option you can apply to the security policy with the action set to ACCEPT.
Answer: A
NEW QUESTION # 64
An administrator has enabled HA session synchronization in a HA cluster with two members .
Which flag is added to a primary unit's session to indicate that it has been synchronized to the secondary unit?
- A. redir.
- B. synced
- C. nds.
- D. dirty.
Answer: B
NEW QUESTION # 65
Examine the following routing table and BGP configuration; then answer the question below.
The BGP connection is up, but the local peer is NOT advertising the prefix 192.168.1.0/24 .
Which configuration change will make the local peer advertise this prefix?
- A. Enable the redistribution of static routers into BGP.
- B. Enable the setting ebgp-multipath.
- C. Enable the redistribution of connected routers into BGP.
- D. Disable the setting network-import-check.
Answer: D
NEW QUESTION # 66
Which configuration can be used to reduce the number of BGP sessions in an IBGP network?
- A. Route reflector
- B. Neighbor group
- C. Neighbor range
- D. Next-hop-self
Answer: A
NEW QUESTION # 67
......
Fortinet NSE7_EFW-7.0 Certification Exam covers a wide range of topics such as firewall policies, NAT, VPN, high availability, and advanced security services. NSE7_EFW-7.0 exam is designed to test the candidate's knowledge of Fortinet's enterprise firewall solutions and their ability to implement and manage those solutions in a complex network environment. Successful completion of NSE7_EFW-7.0 exam demonstrates that the candidate has the knowledge and skills required to design and implement advanced network security solutions using Fortinet's enterprise firewall technology. Fortinet NSE 7 - Enterprise Firewall 7.0 certification is a valuable asset for network security professionals who want to advance their careers in the field of enterprise network security.
RealVCE just published the Fortinet NSE7_EFW-7.0 exam dumps!: https://pass4sures.realvce.com/NSE7_EFW-7.0-VCE-file.html